Kohler k-10950 Maintenance Manual page 17

To Battery/Sensor
To Sensor
AC
Models
Only
To Power Supply
Reassemble the Faucet
For AC models only: Run the AC power cord through the front
hole in the faucet valve to the underside of the deck.
IMPORTANT! Connect the connectors with the arrows pointing
directly toward each other.
Reconnect the sensor connector to the valve connector.
NOTE: "Position 1" is the preferred installation location for the
connectors. "Position 2" may also be used as an alternate installation
location. Refer to the above illustration.
Position the valve/sensor connection tight to the battery clip in
one of the connector positions illustrated above.
IMPORTANT! Verify that all the wires are inside the faucet body so
they are not pinched while installing the valve assembly.
Line up the front of the spout with the pin at the bottom front of
the valve assembly.
Slide the faucet spout over the valve assembly.
One-Year Limited Warranty — USA and Canada
KOHLER plumbing products are warranted to be free of defects in
material and workmanship for one year from date of installation.
Kohler Co. will, at its election, repair, replace or make appropriate
Kohler Co.
Position 2
Important: (alternate)
Connect with the
arrows pointing
toward each other.
To Valve Assembly
17
Position 1
(preferred)
Wire for
AC power
1025498-5-H