Installation; Mains Connection; Audio Connections - Behringer Europower PMP6000 User Manual

13
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual

4. Installation

4.1 Mains connection

The mains connection is made using the enclosed power cord and a standard IEC
receptacle. It meets all of the international safety certification requirements.
Blown fuses must be replaced by fuses of the same type and rating.
◊
Please make sure that all units have a proper ground connection.
For your own safety, never remove or disable the ground conductor
from the unit or of the AC power cord.

4.2 Audio connections

The inputs and outputs of your BEHRINGER EUROPOWER are unbalanced 1/4" mono
jacks—except for the mono channel line inputs, which are balanced 1/4" stereo
jacks. Of course, all inputs and outputs work with both balanced and unbalanced
connectors. The tape in and outputs are on RCA connectors.
◊
Please ensure that only qualified personnel install and operate the
PMP. During installation and operation, the user must have sufficient
electrical contact to earth. Electrostatic charges might affect the
operation of the unit.
Unbalanced ¼" TS connector
strain relief clamp
sleeve
tip
sleeve
(ground/shield)
tip
(signal)
Fig. 4.1: 1/4" TS connector
Balanced ¼" TRS connector
strain relief clamp
sleeve
ring
tip
sleeve
ground/shield
ring
cold (-ve)
tip
hot (+ve)
For connection of balanced and unbalanced plugs,
ring and sleeve have to be bridged at the stereo plug.
Fig. 4.2: 1/4" TRS connector
Balanced use with XLR connectors
2 1
3
input
1 = ground/shield
2 = hot (+ve)
3 = cold (-ve)
1 2
3
output
For unbalanced use, pin 1 and pin 3
have to be bridged
Fig. 4.3: XLR connectors
¼" TRS footswitch connector
strain relief clamp
sleeve
ring
tip
sleeve
ground/shield
ring
FX2
tip
FX1
Fig. 4.4: 1/4" mono plug for footswitch
Power amp insert send return ¼" TRS connector
strain relief clamp
sleeve
ring
tip
sleeve
ground/shield
ring
send (out)
tip
return (in)
Connect the insert send with the input and the insert with
the output of the output e ects device.
Fig. 4.5: Stereo 1/4" TRS connector for power amp ISR connection