Yamaha F40 Owner's Manual page 50

Operation
3. Press the power trim and tilt switch /
power tilt switch "
board motor has tilted up completely.
UP
UP
DN
44
ZMU04066
" (up) until the out-
ZMU01935
UP
ZMU04067
4. Push the tilt support knob into the clamp
bracket or pull the tilt support lever to-
ward you to support the engine.
EWM00260
WARNING
After tilting the outboard motor, be sure
to support it with the tilt support knob or
tilt support lever. Otherwise the outboard
motor could fall back down suddenly if oil
in the power trim and tilt unit loses pres-
sure.
5. Models equipped with trim rods: Once
the outboard motor is supported with the
tilt support lever, press the power trim
and tilt switch / power tilt switch "
(down) to retract the trim rods.
ECM00250
CAUTION:
Be sure to retract the trim rods complete-
ly during mooring. This protects the rods
ZMU04068
"