Beko Oven Manual page 12

Additional protection by a residual
current circuit breaker is
recommended.
2. Fitting a different plug
The moulded plug on this appliance incorporates a
13A fuse. Should the fuse need to be replaced an
ASTA approved BS1362 fuse of the same rating
must be used. Do not forget to refit the fuse cover.
In the event of losing the fuse cover, the plug must
not be used until a replacement fuse cover has
been fitted. Colour of the replacement fuse cover
must be the same colour as that visible on the pin
face of the plug. Fuse covers are available from
any good electrical store.
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals on
your plug, proceed as follows:
• Brown cable = L (Live)
• Blue cable = N (Neutral)
• Green/yellow cable must be connected to
ground (E)
With the alternative plugs a 13 A fuse must
be fitted either in the plug or adaptor or in the
main fuse box. If in doubt contact a qualified
electrician.
3. Open the terminal block cover with a
screwdriver.
4. Insert the power cable through the cable
clamp below the terminal and secure it to the
main body with the integrated screw on cable
clamping component.
5. Connect the cables according to the supplied
diagram.
13/EN
line.
6. After completing the wire connections, close
the terminal block cover.
7. Route the power cable so that it will not
contact the product and get squeezed between
the product and the wall.
Power cable must not be longer than 2
m because of safety reasons.
Gas connection
DANGER
Product can be connected to gas supply
system only by an authorised and
qualified person.
Risk of explosion or toxication due to
unprofessional repairs!
Manufacturer shall not be held responsible
for damages arising from procedures
carried out by unauthorised persons.
DANGER
Before starting any work on the gas
installation, disconnect the gas supply.
There is the risk of explosion!
• Gas adjustment conditions and values are
stated on labels (or ion type label).
• In the UK, Gas Safe registered installers
(Including the Regions of British Gas)
undertake to work to safe and satisfactory
standards.