Advertisement
English
Assembly
Warning! Before assembly, make sure that
the appliance is switched off and
unplugged.
Fitting and removing an attachment
• Use the beaters (4) for blending, beating,
mixing, whisking & creaming.
• Use the dough hooks (5) for kneading.
Assembling the beaters / dough hooks
(Fig. C)
Fit the required beaters through the holes in
the platform (8) or motor housing (4) & push
so they are fully home in the Mixer.
Note: Beater (5B & 6B) must be fitted into
the larger hole (13) on the motor housing (4)
or platform (8 - M650 only).
The beaters can be removed by pressing
down on the release button (2).
Note: The speed control (1) must be at the
0 "Off" position before the beaters can be
ejected.
Note: The platform (8) should be in the
raised position before the beaters are
ejected.
Stand Assembly (Fig. D - M650 only)
With the beaters removed, place the Mixer
on the platform (8) such that the 3 holes
align with the catches & pin. Press down to
lock the Mixer in place.
Press the pivot plate (11) on the back of the
platform & lift it to the raised position.
Fit the required beaters through the holes in
the platform & push so they are fully home
in the Mixer.
Lower the Mixer to the operating position,
ensuring it locks in place.
Use
M300:
Fit the required beaters to the appliance by
inserting them into the 2 holes & pushing
until they are fully home.
Connect the appliance to a suitable
electrical supply.
Place the beaters in the ingredients & move
the speed selector (1) to the desired speed.
Once mixing is completed, the selector
should be returned to the 0 ("Off") position.
Once the switch is in the 0 position & all
parts have stopped moving, the beaters can
be removed by pressing down on the
release button.
M650 (Fig. E):
With the beaters removed, place the Mixer
on the platform such that the 3 holes align
with the catches & pin. Press down to lock
the Mixer in place.
Press the pivot plate (11) on the back of the
platform & lift it to the raised position.
Fit the required beaters through the holes in
the platform & push so they are fully home
in the Mixer.
Note: One beater (5B & 6B) must be fitted
into the larger hole (13) on the motor
housing (4) or platform (8 - M650 only).
Add the ingredients to the bowl (10) , place
the bowl on the stand (7) , and lower the
Mixer to the operating position.
Move the speed selector (1) to the desired
speed.
Once mixing is completed, the selector
should be returned to the 0 ("Off") position.
Press the pivot plate (11) on the back of the
platform (8) & lift it to the raised position.
The beaters can be removed by pressing
down on the release button (2).
-7-
Advertisement
