Sony HT-CT660 Operating Instructions Manual page 29

Menu items Function
SET BT BT.STBY
(BT STAN DBY)
When the system has pairing information, the system is in
BLUETOOTH standby mode even when it is turned off.
• ON: BLUETOOTH standby mode is enabled. The
illumination LED flashes in blue slowly when the system is
turned off.
• OFF: BLUETOOTH standby mode is disabled.
AAC
• If the system does not have pairing information,
BLUETOOTH standby mode cannot be set.
• During BLUETOOTH standby mode, standby power
consumption increases.
Sets whether or not the system will use AAC via BLUETOOTH.
• ON: Uses AAC.
• OFF: Does not use AAC.
• If you change the setting when the system is connected
with a BLUET(bOTH device, the system will be disconnected
from the device.
SYSTEM A. STBY You can reduce power consumption. The Sound Bar enters
(AUTO STANDBY) standby mode automatically when you do not operate the
Sound Bar for about 30 minutes and the Sound Bar is not
receiving an input signal.
• ON: Turns on the "A. STBY"function.
• OFF: Turns offthe function.
IR REP If the remote control ofa TV cannot control the TV, the Sound
Bar can relay the remote control signal to the TV to control
the TV.
• ON: The relay function is enabled.
• OFF: The relay function is disabled.
VER The current firmware version information appears on the
front panel display.
WS LINK Use this item when you want to enable the wireless
transmission (page 30).
RF CHK Indicates whether or not the wireless transmission is
activated on the system.
• RF OK: Wireless transmission is possible.
• RF NG: Wireless transmission is not possible.
t_
29us