Treble Mid Bass Presence - Mesa/Boogie Lonestar Special Owner's Manual

FRONT PANEL: Controls & Features
MID:
The MID control is responsible for the blend of midrange frequencies in the mix and though its effect is not as dramatic as
that of the TREBLE control, it plays an integral part in achieving any sound in your Lone Star Special. It is capable of changing the
feel dramatically as it blends in a group of frequencies that tend to soften or stiffen the way a sound feels to play.
Most players tend to lean in the direction of lower MID control settings (7:00 - 11:00) where a scoop in this region produces girth (by
letting the Bass become a little more dominant) and a lack of punch lends a more compressed, even feel to the strings and therefore
CH 1
FT SW
CH 2
GAIN
CLEAN
THICK
NOR MAL
THICKER
BASS:
The BASS control in your new Lone Star Special works similarly in both channels in that it determines the amount of low
frequencies present in a sound. However, the style of lows it mixes in changes from channel to channel. Like the MID control, it falls
in line signal-wise after the TREBLE control and the same scheme applies. When the TREBLE control is set high, the effectiveness after after the TREBLE control and the same scheme applies. When the TREBLE control is set high, the effectiveness
TREBLE MID
with subtle nuance in mind. This is especially true in Channel 2 when using either the regular Channel 1 style gain circuitry cranked,
or the DRIVE circuitry for higher gain lead sounds. A good rule to follow is this; as you increase the GAIN reduce the BASS. Following
this scheme will retain balance and keep the attack of the notes dynamic, tight and touch sensitive.
PRESENCE:
The PRESENCE control is a high frequency attentuator that is placed at the end of each channels pre-amp stage
and affects frequencies higher than those of the TREBLE control. It acts independently of the other rotary tone controls and is crucial
in voicing the Channel. It is a powerful global tone control. Lower PRESENCE control settings darken and, in fact compress the signal
TREBLE MID
less apparent resistance to the pick. As the MID control is increased, (11:30 - 1:30)
the sound is rounded-out and filled-in with a focused mid attack appearing rather
quickly. As you would guess, the feel starts to change - becoming more resistant.
Above this region the MID control could be used to compensate for either weaker
pick-ups or for times when a specific deficiency is produced by either an extremely
TREBLE MID
high setting of other tone controls, or a physical anomaly in the room. While these
MID control settings (2:00 - 5:00) can introduce added gain and create enhanced
focus, the trade-off will be a stiffer, more forward, less compressed feel.
style of lows style of lows it mixes in changes from channel to channel. Like the MID control, it falls
of the BASS and MID controls is reduced. If the TREBLE control is set low these two controls
become dominant.
For the most balanced sound and a balance of power between the three rotary tone controls,
try to use the TREBLE control in its middle ranges. This scenario produces nearly equal repre-
BASS
sentation of all the frequencies on the tone controls and provides a great neutral starting point
for further tweaking.
Note: The BASS control in both channels of your Lone Star Special is very powerful and
though we have taken steps to ensure a balanced tone is easy to achieve, it is wise to blend
BASS PRESENCE
(Continued)
which works well to fatten single note solo sounds, giving them girth and focus.
Some of the best lead sounds in your Lone Star Special will find the PRESENCE
control in it's lower regions, where a balanced, vocal response is achieved.
PAGE 8
even even feel to the strings and therefore