Table of Contents
Advertisement
Introduction
Technical Specification
Baud rate
Environmental conditions
Front panel
Manufacturing standards
Physical space requirement
(W x D x H)
Power requirements
Weight
1-4
Technical Specifications
Please be aware of the following before connecting the interface module.
Warning! Changes or modifications to the interface module not expressly
approved by Gilson could void the factory-authorized warranty.
The interface module has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC commercial environment.
The system interface generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. Operation of this device in a
residential area is likely to cause harmful interference; in which case, the user will
be required to correct the interference at the user's own expense.
Shielded cables must be used with the interface module to ensure compliance
with the Class A FCC limits.
Definition
19200
Indoor use
Altitude: up to 2000 m
Temperature range: 5–40°C
Air pressure: 75–105 kPa
Pollution degree: 1 or 2, in accordance with IEC 66
Humidity: Maximum relative humidity 80% for
temperatures up to 31°C, decreasing linearly to
50% relative humidity at 40°C
LED indicator lights for RS-232, GSIOC, and Power
Meets applicable Safety and EMC certification
standards; UL and CE certified.
9.4 x 5.5 x 4 cm (3.7 x 2.2 x 1.6 in)
+12V DC at 50 mA supplied via a 2.1 mm ID power
plug. Center contact is positive.
0.14 kg (0.3 lb)
Gilson 508 Interface Module User's Guide
1
Advertisement
Table of Contents
