Items Related To The Audio Control (800S - Sony DVW-A500/1 Service Manual

Items Related to the Audio Control (800s)

The values enclosed in a box are the factory settings.
Item number Item
801 DIGITAL JOG
SOUND
802
DIGITAL AUDIO
MUTE IN
SHUTTLE MODE
803 DIGITAL AUDIO
FADE TIME
804 AUDIO CH3/4
INPUT SOURCE
ARRANGE
Settable range Function
Turns the digital jog sound on or off.
off
0
[on] 0: Digital jog sound is turned off.
[1]
1: Digital jog sound is turned on.
[0]
[off]
Sets the muting conditions for digital audio signals during
1 cueup or preroll
shuttle playback.
2 full
However, the digital audio signal is muted no matter what
this setting is when the tape speed is 24 times normal
speed or more.
0: Not muted.
1: Muted during cue-up or preroll operations.
2: Muted in shuttle mode.
5 ms Specifies the fade processing time during cross-fading or
0
[10 ms]
[1] fading-in/out of digital audio signals.
15 ms
2
Note
3 20 ms
a)
25 ms
4
Processing for cross fading, fading-in, and fading-out starts
b)
5 50 ms
after an IN or OUT point. This item specifies rewriting
6 85 ms
during recording following the OUT point. Rewriting of one
c)
7 115 ms
field occurs even when the minimum setting (5 ms) is
selected. When CUT is selected in item 317 to prevent this
from happening, a discontinuity in the audio signal occurs.
There is, however, no effect on the recording of the video
signal.
a) The cross fade time is 24 ms.
b) The actual fade time is 49 ms.
c) The actual fade time is 114 ms.
[0]
[CH3/CH4 : SW/SW] Select the input signal for digital audio channels 3 and 4.
1 CH3/CH4 : CH1/
0: The signal that is selected by the upper control panel is
SW
2 CH3/CH4 : SW/
1: The signal to be recorded in channel 1 is recorded in
CH2
3 CH3/CH4 : CH1/
2: The signal to be recorded in channel 2 is recorded in
CH2
3: The signal to be recorded in channel 1 is recorded in
Note
The edit preset for channels 3 and 4 is completely
independent. Even if this item is set to "1" and insert editing
is performed with edit preset for channel 1 only, no signal is
recorded in channel 3.
The recording level is determined by the level control of the
input channels used as the source when "1" through "3" are
selected. There is no level control for channels 3 and 4.
The level control for LINE OUT and MONITOR OUT is
completely independent in E-E, CONFI and PB modes
even when the setting is "1", "2" or "3".
Audio signals of digital channels for which speed
compensation has not been conducted are output even
in still-picture mode.
input to channels 3 and 4.
channel 3.
channel 4.
channel 3 while the signal to be recorded in channel 2 is
recorded in channel 4.
A-31
Appendix