Using The Cut-Sheet Feeder (If Fitted) - Oki ML280 Elite User Manual

U C
SING THE UT
1. Place the paper set lever (1) in the RESET position.
2. Release the paper guides by pushing the locking levers
downward.
3. Move the left paper guide (2) to the position where you wish to
set the left-hand edge of the sheet, making sure that this
paper guide is not set to the right of the paper out sensor (the
groove in the platen).
4. "Flex" a paper stack (not more than 170 sheets of 60g/m²
16lb.) paper
(
bending. The stack of paper should not exceed 16mm
thickness.
- F
SHEET EEDER
2
1
1. Paper set lever
2. Left paper guide
3. Rear sheet support
4. Front sheet support
5. Right paper guide
6. Front sheet guide
Square the stack, turn over and repeat the
).
OPERATING YOUR PRINTER > 33
( )
IF FITTED
3
4
5
6