Dmx Channel; Power Supply - American DJ DMX-512 User Instructions

Pocket Scan™ DMX Settings
1 2
DMX512
LEVEL RANGE
PAN TILT COLOR
0 - 255
AUDIO MODE
255
ROTATION CCW
ROTATION CW
200
ORANGE 306
99
YELLOW 601
95
GREEN 204
89
85
79
75
MAGENTA 501
69
MAGENTA 507
65
59
CYAN 104
55
49
45
TORQUES 208
39
35 PINK 310
29
YELLOW 603
25
19
BLUE 101
15
ORANGE 302
9
5
GREEN 201
0
BLACKOUT
2 3 4 5 6 7
Gobo layout. Note gobo one is Large Spot - Open Shutter.
American DJ Supply - www.americandj.com - Pocket Scan™ Instruction Manual Page 12
© ®

DMX CHANNEL

3 4 5 6
GOBO SHUTTER SPEED
AUDIO MODE AUDIO MODE
OPEN
ROTATION CCW
FAST
ROTATION CW
FAST STROBE
WHITE
GOBO 14
GOBO 13
GOBO 12
GOBO 11
UV108
GOBO 10
GOBO9
GOBO 8
RED304
GOBO 7
GOBO 6
GOBO 5
SLOW
GOBO 4
SLOW STROBE
GOBO 3
RELATIVE
GOBO 2
CLOSED
GOBO 1
8 9 10 11 12
Pocket Scan™ Set Up
Unpacking:
Every Pocket Scan™ has been thoroughly tested and has been
shipped in perfect operating condition. Carefully check the ship-
7
ping carton for damage that may have occurred during ship-
LASER
ping. If the carton appears to be damaged, carefully inspect
UNIT RESET
your fixture for any damage. In the case damage has been
OPEN found please contact our toll free customer support number for
further instructions.
FAST STROBE

Power Supply:

Before plugging your unit in be sure the source voltage in your
area matches the required voltage for your American DJ
Scan.™ The American DJ
and 230v version. Because line voltage may vary from venue to
venue, you should be sure to plug your unit into a matching wall
outlet before attempting to operate you controller.
SLOW STROBE
Data Cable (DMX Cable) Requirements:
CLOSED
Your controller and packs require a standard 3-pin XLR connector
for DMX data input and DMX data output (Figure 1). If you are
making your own cables be sure to use standard two conductor
shielded cable (This cable may be purchased at almost all pro
13 14
1 sound and lighting stores). Your cables should be made with a
male and female XLR connector on either end of the cable. Also
remember that DMX cable must be daisy chained and can not
be "Y"ed or split.
Notice:
Do not use the ground lug on the XLR connector. Do
not connect the cable's shield conductor to the ground lug or
allow the shield conductor to come in contact with the XLR's
outer casing. Grounding the shield could cause a short circuit
and erratic behavior.
DMX512 OUT
CONTROLLER
CONNECTOR
3 PIN
American DJ Supply
©
Pocket Scan ™
®
COMMON
DMX +
1
3
DMX -
2
Figure 2
- www.americandj.com - Pocket Scan™ Instruction Manual Page 5
®
Pocket
®
is available in a 115v
DMX512 IN
1
CONNECTOR
3
3 PIN
2