Wolf MWD24-2U/S Installation Manual page 7

INSTALLATION
Preparation
Remove and recycle packing materials. Do not remove the
waveguide cover, which is located on the upper surface of
the drawer interior. Refer to the illustration below.
Installation
Turn power off to the electrical outlet.
1
Move the unit near the opening. Plug the power cord into
2
the grounded outlet.
Position the microwave oven in the opening and slide
3
back until the mounting flange is flush with the face of
the cabinet. Avoid pinching the power cord between the
unit and cabinet wall.
Open the drawer. Using the two holes on either side of
4
the mounting flange as a template, pre-drill mounting
holes into the cabinet using a
Mount the microwave oven with the four screws pro-
5
vided. Refer to the illustration below.
Turn power back on to the electrical outlet.
6
WAVEGUIDE
COVER
Waveguide cover.
Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc. Sub-Zero, Sub-Zero &
Design, Dual Refrigeration, Constant Care, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, and Ingredients are registered trademarks and service marks
of Sub-Zero, Inc. (collectively, the "Company Marks.") All other trademarks or registered trademarks are property of their respective owners in the United States and other countries.
1 / " drill bit.
16
MOUNTING
FLANGE
Mounting.
Troubleshooting
IMPORTANT NOTE: If the drawer microwave oven does not
operate properly, follow these troubleshooting steps:
• Verify electrical power is supplied to the microwave
oven.
• Verify proper electrical connections.
• If the microwave oven does not operate properly, contact
Wolf factory certified service. Do not attempt to repair
the oven. Wolf is not responsible for service required to
correct a faulty installation.
|
wolfappliance.com 7