Advertisement
HacethetreadmHU
inthestorage position (seeHOWTO
FOLD ANDMOVE THETREADMILL onpage20),
Next,pUace thecylinder e ndoftheShock (92)nearthe
bracket o nthebaseofthe Uprights ( 84),
Seethetwosmallinset d rawings, U sing yourfingernail
ortheendofa screwdriver, pressontheendofthe
ShockPin(25)to loosen itfromtheShock(92),Next,to°
tatetheShockPinandpullitoutoftheShock, B ecare-
ful to avoidtosingthe ShockPin.
Seedrawing 5a,Press thecylinder e ndof theShock (92)
ontotheballonthebracket, Next,insert t heendofthe
ShockPin(25)through twoofthesmall h obsintheend
oftheShock, T hen,rotate theShock Pinuntilit clips
ontotheShock,
9_/_
Bracket
25
/_
Cylinder
_.._
25
Raise the Shock (92) to a vertical position, Remove the
Shock Pin (25) from the raised end of the Shock as de-
scribed in step 5, if necessary, rotate the Shock to align
the end of the Shock with the ball on the bracket on the
Frame (58),
Next, press the Incline increase and decrease buttons
until the ball on the bracket is aligned with end of the
Shock (92), Then, press the end of the Shock onto the
ball, Note: it may be necessary to press the end of the
Shock onto the ball while the Frame is moving,
See drawing 6a, insert the Shock Pin (25) into the two in-
dicated small hobs in the end of the Shock (92), Then,
rotate the Shock Pin until it clips onto the Shock, Note:
Extra Shock Pins are included,
Press the Incline decrease button until the treadmill is at
the lowest incline level, Then, unplug the power cord,
6a
Bracket
/
7, Make sure that aH parts are properly
tightened
before you use the treadmill,
if there are sheets of clear
plastic on the treadmill decals, remove the plastic, To protect the floor or carpet, place a mat under the tread°
mill, Note: Extra hardware may be included, Keep the included allen wrench in a secure place; the large allen
wrench is used to adjust the walking belt (see page 23),
8
Advertisement
