Advertisement
Available languages
Available languages
5. Remove either top or back wiring
knockout
and
install approved
Electrical
Cable Clamp.
ELECTRICAL
CABLE
CLAMP
6. Remove appropriate
Duct Knockout(s)
from top
or back of
hood.
TOP RECTANGULAR
DUCT KNOCKOUT
(REMOVE FOR 31/4" X 10"
VERTICAL & FOR 7"
ROUND DISCHARGE)
SEMI-CIRCULAR
DUCT KNOCKOUT
(REMOVE FOR 7"
ROUND DiS-
CHARGE)
7. 31/4" x 10" Ducted Discharge
Only:
Attach
Damper/Duct
Connector
over knockout
opening.
Make sure damper
Pivot is nearest to
Top/Back
Edge of hood.
Remove
Tape from
damper
flap.
8. 7" Round Ducted Discharge
Only:
Re-install
7" Round Duct Plate removed
in Step
#1 under "PREPARE THE HOOD"
section. Install a
7" round damper
(purchase separately).
Damper
flap must open freely in direction of air flow (away
from range hood).
REAR
RECTANGU LAR
DUCT KNOCKOUT
(REMOVE FOR 31/4" X 10"
HORIZONTAL
DISCHARGE)
UP TO 1"
SIDE-TO-SIDE
ADJUSTMEN
TAPE
TOP/BACK
EDGE
To accomodate
off-center
ductwork,
the Damper/
Duct Connector
can be installed
up to 1-inch on
either side of hood center or the 7" Round Duct
Plate can be installed
up to V2 on either side of
hood center. In extreme
off-center
installations,
one end of the duct connector
may need to be
trimmed
to clear the electrical
cable clamp.
PIVOT
DAMPER/DUCT
CONNECTOR
(VERTICAL
DISCHARGE
POSITION
SHOWN)
8
Advertisement
