Advertisement
FRONTVIEW
BACK VIEW
20
19
12
18
17
14
-14
FRONT ViEW
BACK VIEW
1. Handle Grip
2. FrontPanel ReleaseHandle
3. FrontPanel
4. Headlight
5. Bumper
6. Clear Dirt Window
7. Hose
8. UpperHeseWrap
9. CordGuide
10. Dust Brush
11. ToolCaddy
12. Extension Wand
13. Extension Wand Holder/Hose Clip
14. Wheels
15. Handle ReleasePedal
16. On/Off Pedal
17. Lower Cord Wrap
18. Power Cord
19. Crevice Tool
20. UpperCord Wrap with Quick Cord
Release
TOOL R EQUIRED:
PHILLIPS S CREWDRIVER
BODY ASSEMBLY
WARNING:
BEFORE
ASSEMBLING THE BODY
OF THE CLEANER TO
BASE,
MAKE
SURE
POWER CORDIS DOWN
AND OUT OF THE WAY
TO AVOID PINCHING
CORD.
Place front panel on
by putting its bottom
tab in the slot on the
vacuum (inset).Close
until it snaps into
place(Diagram3).
Place the bodyofthe cleaner o ntobase(Diagram 2).
Pushtogetherfirmly.Insertlongerscrew into the
front ofbodyof cleaner t o secure (Diagram 2a).
HANDLEASSEMBLY
Slide handle down
onto the body of the
cleaner.
TOOL CABBY, HOSE, A NDTOOL ASSEMBLY
Inserttab on tool caddy into
slot above screw holes on
back of handle,
Bring tool caddy down to fit against
handle.Inserttwo (2)screwsto secure
caddy and handle sections. Tighten
screws to secure.
HOSE ASSEMBLY
Holdlower cord wrap'
place while insertim
one (1) screw. Tighten
until secure.
BACKVIEW
HoldExtensionWand Holder/HoseClip in
place while inserting one (1) screw.
Tightenuntil secure.
Push curved end of hose
onto the back of unit.
6
Wrap hose around storage
hook as shown.
Advertisement
