Ice Size Selection - Danby Designer Ice'N Easy DIM1524W Owner's Manual

1 Add water to 'fill line'. _''
13 Changethe ice size if you
. don't want medium cubes.
To immediately begin the ice
making process;
. Remove ice bucket and add
water to Fill line (approx 3 5 L)
• Reinsert the ice bucket and
press the Power button
• Select the desired ice cube
size (See "Ice Size" below)
* The ice maker will automati-
cally begin approximately t5
seconds after the last button
is pressed
Please note: The length of
the ice making process is
directly proportionate to the
current ice size setting and
batch completion time range
between 9 minutes and I5
minutes per cycle, depending
upon your ice size selection
For optimal results, please
keep the ice maker door
closed during the ice making
process,
i;Selection button On the
1 Add water to !fili line'.: :[iI:
The ice size selection button
allows you to choose from
small, medium or large ice
cubes
By default your ice maker is
configured to produce medi-
um size ice cubes,, However
if you would like a different
size of cube, you need only
depress the ice size selection
button to cycle between the
three (3) available sizes
(small, medium and large,)
Ice size change is possible
during the running ice making
cycle, however it is recom-
mended to wait until the cur-
rent cycle is complete before
defining a new ice size,
NOTE: Unless there is a
power failure or power inter-
ruption to the unit, The ice
size selection you have made
will be retained as the default
ice size,
'3 Press the increase & :: _:
• Remove ice bucket and add
water to Fill line.(approx, 3,5 L)
• With the power off Press
the IncreasetDecrease but-
tons once simultaneously to
enter the timer set mode.
- Each subsequent press of
the increase button will
increase the timer in 30
minute increments up to 12
hours, Alternatively to
subtract time from the timer,
press the decrease button to
decrease the timer by 30
minute increments
• Reinsert the ice bucket and
select the ice size you
require,
• The ice maker timer wilt
automatically start I0 sec-
onds after the last button is
pressed
To cancel the timer at any
time and begin the ice making
process immediately, simply
press the power button,,