Controls And Functions; Front Panel - American DJ Audio DCD-PRO450 Instruction Manual

CONTROLS AND FUNCTIONS

Front Panel:

4
1 2 3
18 19 20
A. Remote unit front (figure 11)
1. SKID/COAST/ADJUST - This button allow you to
change the SKID and COAST values. With the SKID/
COAST/ADJUST selected the SKID value is one second
and the COAST value is five seconds. With the SKID/
COAST/ADJUST deselected (off) the SKID value is a 1/2
second and the COAST value is three seconds.
2. CUE MEMORY - This button allows you to program up
to 4 cue points on the CD, first set a cue point (See Cue
Section). Press the MEMORY Button (2) during play or
pause, the memory LED lights up. Use frame search to
reach desired point, then press a number button to memo-
rize that starting point. Repeat above steps to memorize all
4 starting points if desired.
3. SKID BUTTON - This button activates the SKID effect.
This effect simulates the sudden platter stop of a turntable.
Almost like pressing the stop button on a turntable. When
the SKID effect is selected a number 1 will appear in the
LCD Display (13), this indicates SKID effect is selected.
4. REV/PLAY BUTTON - This button activates reverse play
mode. When this effect is selected the disc will begin to
play in reverse mode, and continue to play in reverse until
reverse play is turned off. If reverse play is not turned off
the disc will continue to play in reverse until it returns to
the beginning of the disc. When the REV/PLAY effect is
selected a number 3 will appear in the LCD Display (13),
this will indicate REV/PLAY is selected.
5 6
7
23
21 22
American DJ AUDIO • DCD-PRO450™ INSTRUCTIONS MANUAL • PAGE 6
®
8 9 10
24 25
5. TIME BUTTON - The TIME button is used to changed
the displayed time values. Time can be displayed as
ELAPSED PLAYING TIME, track REMAINING TIME and
TOTAL disc REMAINING TIME.
6. CUE BUTTONS - These button are used to store 4 user
programmable "Cue Points." A "Cue Point" is a starting
point anywhere on a disc. To program a "Cue Point" see
Cue Points on page 10.
7. PROGRAM - This button is used to enter Program
Mode. The word "PROGRAM" will be indicated in the
display when Program Mode is activated. To program see
"Programming" on page 11.
8. REPEAT - This button allows you to select between
REPEAT 1 or REPEAT ALL. Repeat 1 will continuous repeat
the selected track. Repeat All will continuously repeat
the disc. The repeat function will work in program mode,
repeating a single track or repeating the entire program.
9. SGL/CTN - This function allows you to select single or
continuous play. Single play will return a track to it's cue
point when it has completed play. Continuous play will play
the entire disc until the last track has completed play.
10.OPEN/CLOSE (Disc Tray Open/Close) - This button is
used to load or eject the disc tray. Each press will open or
close the disc transport tray. NOTE: The tray will not open
unless the disc is in pause or cue mode.
11 12 13 14
26 27 28 29
15 16 17
Fig. 3
30