Panasonic AW-HE50HN Operating Instructions Manual page 16

Parts and their functions
9 LAN connector for IP control [LAN ACT/LINK]
This LAN connector (RJ45) is connected when exercising
IP control over the unit from an external device.
Use a cable with the following specifications for the
connection to the LAN connector:
When connecting through a hub:
LAN cable* (category 5 or above, straight cable),
max. 100 meters [328 feet]
When a hub is not used:
LAN cable* (category 5 or above, crossover cable),
max. 100 meters [328 feet]
*: Use of an STP (shielded twisted pair) cable is
recommended.
 Anti-theft wire mounting hole
Use this hole to attach the wire bracket.
 HDMI connector [HDMI] (AW-HE50H only)
This is the HDMI video output connector.
 Hole used to secure cable cover
Use the screw provided to secure the cable cover.
 MULTI-I/F connector [MULTI-I/F]
This is the camera's HD/SD component video signal,
composite video signal and camera's control signal
connector.
Use the multi‑interface cable purchased separately or a
cable with the DX40M‑20P (made by Hirose) connector
specifications as the connecting cable.
Pin
10A 1A
No.
1A Y OUT
1B Y GND
2A Pb OUT
10B 1B
2B Pb GND
p p The above figure
3A Pr OUT
shows the pin
3B Pr GND
layout of the
4A VIDEO OUT
connector on the
4B VIDEO GND
camera as seen
from the outside.
5A TALLY
5B T GND
 DC IN connector [12V
Connect the AC adapter supplied with the unit to this
connector to supply the DC 12 V voltage to the unit.
 Cable clamp
This is used to hold the cable connection to the DC IN
connector and prevent it from becoming disconnected.
Pin
Signal name Signal name
No.
6A RX+_IN
6B RX–_IN
7A TX+_IN
7B TX–_IN
8A GND
8B GND
9A RX+_OUT
9B RX–_OUT
10A TX+_OUT
10B TX–_OUT
IN ]
 IR ID switches [IRID]
[CAM1] [CAM2]
These are used to select the ID of the wireless remote
control (optional accessory).
The IR ID switch settings "CAM1" to "CAM4" correspond
to the [CAM1] to [CAM4] buttons on the wireless remote
control.
 Square holes (2) for cable cover tabs
The tabs on the two sides of the cable cover are fitted
into these holes.
 SYNC IN connector [EXT SYNC IN]
(AW-HE50S only)
This is the external sync signal input connector.
This unit supports the BBS (Black Burst Sync) signal as
the external sync signal.
 SDI OUT connector [HD/SD SDI OUT]
(AW-HE50S only)
This is the SDI video signal output connector.
 Threaded hole (thread: 1/4-20UNC) for mounting
the camera
Use this hole when mounting the camera on a tripod, etc.
 Service switches
SW1 SW2 SW3 SW4
ON
OFF
The camera is used with all the switches at the OFF
setting.
16
[CAM3] [CAM4]
SW5 SW6 SW7 SW8