Using The Air Conditioner - Sears Kenmore Room Air Conditioner Owner's Manual

Using the Air Conditioner
NOTE: If the air conditioner is turned off,
wait 3 minutes before restarting This
allows pressure inside the compressor to
equalize Failure to follow these
instructions may cause inefficient
operation.
To reduce the risk of fire, electric shock, or injury to persons, read the
IMPORTANT SAFETYINSTRUCTIONS before operating this appliance
To begin operating the air' conditioner, follow these steps:
t Plug in the airconditioner (To prevent electrical hazards, do not usean extension
cord or an adapter plug_)
2 Set the exhaust vent to the CLOSEDposition
3 Set the TEMP Control to the coolest setting
4 Set the fan control at the highest levet
5 Adjust the louvers for comfortable air flow
6 Once the room has cooled, set the fan to the POWERSAVER FAN setting and/
or adjust the TEMP Control to the setting you find most comfortable
Air Conditioner Features
VENT
EXHAUST CLOSED
Kenmore
FAN
OFF
:.. ,,
LOW LOW
POWER NORMAL
SAVER
TEMP
COOLER
HEAVY DUTY
FAN= OFF cool
:::: HIG IGH.
HEATConirol (some models)
Review the "Air Conditioner Features" section for other settings
The controls featured in this manual are representational of the many models
available Your model may look shghtty dsfferent
TEMP Control
The TEMP Control serves as the thermostat to set the degree of room coolness
Turn the knob clockwise from thin rule to thick rule to increase the cooling
temperature
FILTER MONITOR (some models)
To check filter monitor:
t Set NORMAL fan control to HIGH setting,
2. If filter needs cleaning, a RED indicator will appear in the filter monitor
window A clean filter will help reduce operating costs and increase cooling
efficiency
NORMAL Fan
When in the NORMAL Fansetting, the air conditioner runs all the time, circulating
the air' Cooling starts only if the room temperature rises above the coolness level
selected on the TEMP Control, and stops once the set coolness level is reached
This setting gives the most even room temperatures.
POWER SAVER Fan (some models)
The POWERSAVERFan can save energy tn this setting, the fan will not run unless
the TEMP Control is set colder than the room temperature When the TEMP
Control is set colder-than room temperature, the air conditioner will begin to
drculate the air in the room Cooling will begin in about 3 minutes The air
conditioner turns off automatically when the room reaches the level of coolness
selected HIGH isfor fast cooling, MED is for normal cooling, and LOW isfor quiet
cooling
FAN
POWER NORMAL
SAWR OFF
HIGH HIGH
MED. MED,
TEMP
VENT
CLOSED
COOLER
LOW
LOW
Side Air Model Control Panel
EXHAUST