Front Installation - Sears Kenmore Room Air Conditioner Owner's Manual

I II .j_, ..............................
Front Installation
,,1
L
Installing Bottom RailSeal
Vertical
Screw
Unit Cover
Horizontal
Louvers Front Panel
Front Installation - Side Air Discharge
FIG,
Installing Bottom Rail Seal (some models)
Some models are shipped in a removable sleeve that must be positioned properly
forsafeand effidentsealing Followthe Installation Instructionssupplied To install
the Bottom RailSeal, position the seaton top of the bottom rail, flush with the front
edge of the rail and in contact with the side seals
Manual Vertical Louver Adjustment (side air discharge)
Complete this adjustment before installing front panel
1 Adjust the vertical louvers to the straight position by using the handle,
2 The dial plate and knobs are packed separately. To install them, refer to
Installing the Dial Plate and Front Frame section on the next page
Front Installation - Some Side Air Discharge Models (FIG. 1)
Install the front panel with filter as follows:
t Adjust the horizontal louvers to the straight position Hold the front straight
until the vertical louver handle lines up between the bottom horizontal louver
and the discharge opening
2 Pressthe front straight onto the cabinet until the holes in the flange of the
plastic front line up with the screw holes in the metal cabinet Fasten the front
panel in place with the two screws provided
Installing the Vent Control (on some models)
The vent control handle isincluded in the decorative front kit The handle must be
installed before the decorative front is attached. See illustration below
1, Insert the handle with the tab facing the right
2 Snap the slot of the clear actuator strip over handle tsb
3. PRESSstrip in place from the back of the tab, as shown below, until tab "clicks"
into position
4 Move handle in and out to be sure vent is operating properly If not, repeat
above procedure until vent operates properly
VENT' PULL !
PLACE CLEAR
STRIP OVER TAB ON
VENT PULL
RESS
ERE
4