Advertisement
Available languages
Available languages
For best cleaning results, the dust bag
should be changed before it gets full. Use
dust bag no. 5231FI2390J
1. Unplug cord from wall outlet.
2. Pull lid release latch out and up,
then lift canister hood.
3. Press back the bag mount hook.
_Lid
Release
_!_
CAUTION
NEVER REUSE A DUST BAG. Very fine
materials, such as carpet freshener,
face powder, fine dust, plaster, soot,
new carpet lint, etc., can clog the bag
and cause it to burst before it is full.
Change bag more often when
vacuuming these materials.
4. Remove used bag and throw it away.
5. To insert new dust bag:
• Press back the bag mount hook.
• Fit bottom edge of bag mount tab
onto bag mount ledge.
• Pull bag mount tab flush with suction
inlet hole.
• Secure bag mount hook over top edge of
bag mount tab.
Bag Mount Tab
Bag Mount kedge
6. Close and latch canister hood.
NOTE: The vacuum is fitted with a safety
device which prevents you from closing the
canister hood if the bag is not fitted correctly.
7. Plug cord into wall outlet.
_!_
WARNING
Electrical Shock Hazard
Do not operate the cleaner without the
motor safety filter. Be sure the filter is
dry and properly installed to prevent
motor failure and/or electrical shock.
Check motor safety filter occasionally
and clean when dirty.
1. Unplug cord from wall outlet and
remove bag.
2. Pull out safety filter as shown.
3. Wash filter in warm soapy water, rinse,
then dry. Do not clean in dishwasher or
install while damp.
4. Insert filter back into canister.
5. Insert bag.
--9--
Advertisement
