Black & Decker CM1936 Instruction Manual page 6

pREpARATIoN
plEAsE REfER To DIAGRAMs (A, B, C...) AND ITEM NuMBERs (1, 2, 3...) As NoTED ThRouGhouT MANuAl. foR ExAMplE,
A-1 REfERs To ITEM 1 IN fIGuRE A.
uNpACkING - (fIGuREs A, A1, A2)
sTEp 1:
Raise the handle section A-1 into place and secure by tightening the two
lower knobs A-2. Be careful not to pinch power cord.
CAuTIoN: pinch point. To avoid being pinched, keep fingers away
from area between handles when raising.
sTEp 2:
Carefully cut down the sides of the box on the opposite end of the handle
and fold the flap down as shown.
body parts away from blade.
sTEp 3:
With the carton end cut open, remove the cardboard filler, charger,
accessory bag and grass bag and push the mower out of the opened
carton.
hANDlE ADjusTMENT - (fIGuRE B)
Your mower has a variable height handle adjustment feature. To adjust the
handle position to suit your height preference, use the following procedure:
1. Remove both hex nuts and flat washer B-1 on the middle part of the
handlebars using a 1/2 inch wrench. Remove the carriage bolts B-2.
2. Slide the upper handle into one of the 3 adjustment positions B-3,
aligning the holes in the upper and lower handles.
3. Insert carriage bolts and install the flat washers and hex nuts, tighten
securely.
sharp blade. Keep
wARNING:
A
A1
A2
B
6
6