Before connection
Important!
Ensure that your appliance has not suffered any damage during transport (bent door or seal,
■
etc.). If you notice any kind of damage, contact your retailer before using the appliance.
In order to easily locate the make, model number, etc. of your appliance, we recommend that you
■
note this information on the 'Warranty and service' page.
If the power cable is damaged, it should be replaced by the manufacturer, its after-sales service
■
department or by a similarly qualified person on order to avoid danger.
Installation should only be performed by installers and qualified technicians.
■
Electrical specifications
Electrical connection rating: 3.4 kW
■
Voltage/frequency: 220-240 V / 50 Hz
■
Current: 16 A
■
Please verify electrical specifications by checking the appliance rating label.
Electrical connection
Ensure that:
The electrical installation has sufficient voltage.
■
The electrical wires are in good condition.
■
The diameter of the wires complies with the installation requirements.
■
Your electrical installation is equipped with 16-ampere thermal-sensitive protection.
■
The oven is connected to a single phase 220-240 V 50 Hz supply using a 1.5 mm
■
connected to earth. The supply must be protected by a suitably rated circuit breaker in
accordance with the installation regulations.
A suitable isolating switch providing full disconnection from the mains power supply is
■
incorporated in the permanent wiring, mounted and positioned to comply with the local wiring
rules and regulations. The isolating switch must be of an approved type and provide a 3 mm air
gap contact separation in all poles (or in all active [phase] conductors if the local wiring rules
allow for this variation of the requirements)
The isolating switch will be easily accessible to the customer with the oven installed.
■
If in doubt, consult your electrician.
■
Electrical connections should be completed before the appliance is placed in the wall unit.
The appliance must be recess-fitted correctly to ensure electrical safety. During recess fitting and
maintenance operations, the appliance must be disconnected from the power supply; fuses must
be cut off or removed.
If the power cable is damaged, it should be replaced by the manufacturer, its after-sales service
or a similarly qualified person so as to prevent a hazard.
Important:
We cannot accept liability for any accident or incident resulting from non-existant, defective or
incorrect grounding.
If the oven malfunctions in any way, disconnect it from the power supply or remove the fuse for
the oven's connection line.
Installation instructions
7
2
cable and