Hotpoint NCD 191 I Operating Instructions Manual page 3

Fitting a new plug
IMPORTANT: : : : :
WIRES IN THE MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE...
As the colours of the wires in the mains lead may
not correspond with the coloured markings
identifying the terminals in your plug, proceed as
follows:
- Connect Green and Yellow wire to terminal
marked 'E' or or coloured
Yellow.
- Connect Brown wire to terminal marked 'L' or
coloured red or brown.
- Connect Blue wire to terminal marked 'N' or
coloured Black or Blue.
If a 13amp plug (BS 1363) is used it must be
fitted with a 13amp fuse. A 15amp plug must be
protected by a 15amp fuse, either in the plug or
adaptor or at the distribution board.
If you are in any doubt about the electrical
supply to your machine, consult a qualified
electrician before use.
CE Marking certifies that this appliance
conforms to the following EEC directives :
Low Voltage Equipment - 73/23/EEC & 93/68
EEC
Electromagnetic Compatibility 89/336/EEC, 92/
31/EEC & 93/68/EEC
Green and Yellow - Earth
Blue - Neutral
Brown - Live
Green and
EN
3