Trane XT302C Installer's Manual page 8

XT302C DELUXE PROGRAMMABLE HEAT-COOL THERMOSTAT
2. Press Day until the current day displays.
Set Current
Run
Wake Leave Return
Program Day/Time
Day
Time Set Program
Heat/Cool
Hold Temp Day Filter System
Settings
Daylight Copy
Time
NOTE: Sun=Sunday, Mon=Monday, Tue=Tuesday,
Wed=Wednesday, Thu=Thursday, Fri=Friday,
Sat=Saturday.
3. Press Time or Time
Time
Set Current
Run
Wake Leave
Program Day/Time
Time Set Program
Heat/Cool
Hold Temp Day Filter System
Settings
Daylight
Copy
Time
NOTE: Tapping the Set Current Day/Time will change the
time in one hour increments.
NOTE: If the current time is Daylight Savings Time, press
Daylight Time until DST displays.
Daylight
Run Set Current
Wake Leave Return
Program Day/Time
Time Set Program
Time
Heat/Cool
Hold Temp
Day Settings Filter System
Daylight Copy
Time
4. Press Run Program.
Run
Run Set Current
Wake Leave
Program Day/Time
Program Time Set Program
Heat/Cool
Hold Temp Day Filter
Settings
Daylight
Copy
Time
INSTALLER SELF-TEST
Use the Installer Self-Test to check the thermostat operation.
Refer to Table 4 for a list of the available self-tests.
CAUTION
Equipment Damage Hazard.
Equipment damage can occur if the compressor
is cycled too quickly.
The minimum off time is deactivated during the
Installer Self-Test.
Perform the test so that the compressor is cycled
slowly.
Pub. No. 18-HD25D7-5
69-1213—1 (T8624)
Set Day/Time
PM
Tue
Sleep
Fan
M12952
until the current time displays.
Set Day/Time
AM
Tue
Return Sleep
Fan
M12953
Set Day/Time
AM
Tue
Sleep
DST
Fan
M12954
AM
Room
Tue
Return Sleep
Wake
System DST Fan
System Fan
Heat
M12955
To start the self-test:
Press and hold the Increase
same time until all display segments and the number 10
appears (all displays segments appear for approximately
three seconds before the test number displays). See
Figs. 12 and 13.
Table 4. Tests Available In The Installer Self-Test.
Test
Number
10 Heating Equipment
30 Cooling Equipment
40 Fan Equipment
50 Comfort-R Terminals (H-H)
60 Keyboard Operation
70 Device Information
Set Program
Hold for
Em Ht
Aux Ht
Mon TueWedThuFriSatSun
Wake LeaveReturnSleep
System
Em Heat Off
Fig. 12. Display of all the segments of the LCD.
Auto
Fig. 13. Display of test number.
Refer to Table 5 for the directions and results of the specific tests.
NOTE: Press Time
to go back to the previous test. Press Run Program to
exit the self-test. This mode times out 5 minutes after
the last key press.
NOTE: Press Time
to advance to the next test.
NOTE: To exit, press Time
8
and Decrease
Self-Test Description
Temporary Setting Enrg
Start Time Set Day/Time
AM
PM
Heat Cool
In Recovery Auto
Fan
DST
Cool Auto Wait
TEST NUMBER
to advance to the next test and Time
to return to the previous test or Time
or Time then Run Program.
keys at the
Sav
Room
Outdoor
Repl Batt
On Auto
M17111
M10257A