Table of Contents
Advertisement
3. HARDWARE SETUP
4) Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN output. The
connector powers up the system when a wakeup packet or signal is received
through the LAN card.
IMPORTANT: This feature requires that Wake On LAN or PCI Modem
parameter is enabled (see 4.5.1 Power Up Control) and that your system has an
ATX power supply with at least 720mA +5V standby power.
CUV266-DLS
CUV266-DLS Wake-On-LAN
Connector
5) Wake-On-Ring Connector (2-pin WOR)
This connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ring up packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.
IMPORTANT: This feature requires that Wake On LAN or PCI Modem
parameter is enabled (see 4.5.1 Power Up Control) and that your system has an
ATX power supply with at least 720mA +5V standby power.
CUV266-DLS
CUV266-DLS Wake-On-Ring
Connector
ASUS CUV266-DLS User's Manual
1
0
1
0
1
0
1
0
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power.
+5 Volt Standby PME
1
0
1
0
1
0
1
0
WOR
RI#
2
WOL_CON
Ground
Ground
1
35
Advertisement
Table of Contents
