Sears Vacuum Cleaner Owner's Manual page 14

IGHT
!. Remove light
cover by pressing in
and lifting both sides
as shown,
Push In And Turn
To lnstalJ
2. Push in and turn
bulb counterctocko
wise to remove,
3. Replace with bulb,
Bulb must not be
higher than t5 wafts,
Close light cover
until it snaps in place.
ELT
Disconnect cleaner from electrical ouftet. Check and
remove hair, string and lint build-up frequently in the
POWER-MATE
TM
brusbr'and brush support areas, If
build-up becomes excessive, disconnect POWER-
MATE
TM
from wand and follow the steps below,
Instructions can also be found under the light cover,
TO REMOVE BELT:
1. Remove light cover
and light bulb as
shown under "LIGHT
BULBCHANGING,"
2. Unscrew the
POWER_MATE
TM
cover
screws.
& Turn POWER-
MATE
TM
over, To
remove cover.
insert screw-dri-
ver at cover
tabs on both
sides and twist
to release tabs,
5. Carefully
insert and
twist screw_
driver at
each brush
support to
free brush
from base,
Quick
Release
Brush
Support
4o Turn POWER°
MATE
TM
right side
up, Press handle
release pedal
and lower the
swivel, Tilt cover
forward from
back until front
snaps free,
6. Remove worn
belt,
7. Slide brush
supports off to
check and clean
brush support
areas, See page
]5 for picture of
complete brush
assembly_
13