Acer P7203/P7205/P7200i User Manual page 36

26
Keystone Adjust image distortion caused by tilting projection. (±40 degrees)
H Keystone
Press the
a squarer image.
V Keystone
Press the
squarer image.
H. Position
•
(Horizontal
•
position)
V. Position
•
(Vertical position)
•
Frequency "Frequency" changes the projector's refresh rate to match the
frequency of your computer's graphics card. If you can see a vertical
flickering bar in the projected image, use this function to make the
necessary adjustments.
Tracking Synchronizes the signal timing of the projector with the graphics card.
If you experience an unstable or flickering image, use this function to
correct it.
Sharpeness Adjusts the sharpness of the image.
•
•
•
PIP
•
PIP Source
Press
S-Video or Component signal.
PIP Location Choose the PIP secondary signal location on the display screen.
PIP Size Choose the PIP secondary signal size on the display screen.
Note: "H. Position", "V. Position", "Frequency" and "Tracking" functions
are not supported under HDMI, DVI or Video mode.
Note: "Sharpness" function is not supported under HDMI, DVI or computer
mode.
Note: PIP, PIP source, PIP Location and PIP Size are not supported under
Video mode.
or to adjust image distortion horizontal and makes
or to adjust image distortion vertical and makes a
Press to move the image left.
Press to to move the image right.
Press to move the image down.
Press to move the image up.
Press to decrease the sharpness.
Press to increase the sharpness.
Choose "On" to to see two screens at the same time.
Choose "Off" to disable the function.
and to choose the secondary video source: Composite,