Installing The Charcoal Filler - GE EMO3000 Installation Instructions Manual

Installation Instructions
[_ MOUNT THE MICROWAVE
OVEN (cont.)
[] lnserl 2 self:aligning screws
through outer top cabinet
holes. "I_lrn lwo full turns on
each screw.
]Tighten center
screw completely.
[] Tighten the outer two screws to file lop of tile
microwave oven. (While tightening screws, hold
tile microwave oven in place _gainst tile wall and
the lop cabinet.)
1400and 1600Series
1800Series
[] Install grease filters. See the Owner's Manual
packed with the microwave.
INSTALLING THE
CHARCOAL FILTER
[] On 1400 and 1600 Series models, remove screws
on front of grille using a #1 Phillips screwdriver.
On 1800 Series models, reInove screws on top
fl'ont of grille using a #2 Phillips screwdriver.
[] Open the door.
[] ReInove tile grille.
On 1400 and 1600 Series models, pull the grille
straight off
On 1800 Series models, slide tile grille to tile left
and pull it straight of L
Charcoal
f Filter
[] Install the charcoal filter. When properly installed,
the wire mesh of the filter should be visible ffmn
the front.
[] Replace tile grille and tile screws.
[] Close 1he door.
insert mesh-side up
22