GE ZMC1095 Installation Instructions Manual page 5

Design hfformation
hbxill-In Micl'OWaV¢/( onv¢clion Oven
Remove Gidlle
Beta|no Screws
• Open tile door.
• Reinoxe tile _\x(i (2) retainer screx_s fl'om tile
bottoin side of tile grille (one at each side).
• Roll tile grille fi)r\_,ard fix)in tile bottoIn.
• Disengage tile locating tabs, and remox e tile
grille flxiin tile unit.
Note: Grille appearancevaries
depending on model.
Install Side
Trim Jbr 30"
Appearance
If you are installing in a 27" opening, skip this
step and discard tile optional side triin.
For a 30" installation appearance:
• Slide one side of tile (wen ()tit of tile opening
about 4" to 5", leaving tile opposite side
against the cabinet. Tile oven should be at
about
30 ° angle
in tile opening which will
allow easier access to tile side triin screws.
• Reinove tile two side triin screws.
• Hold a side triIn piece against tile oven with
screw holes aligned. Reinstall original screws.
Note:4 extrasidetrimscrewsareprovided foryourconvenience.
• Lift tile ()veil by tile bottoin, pull out and
turn tile ()veil to expose tile opposite side.
CAUTION: L IFTTHEOVENFROMTHEBOTTOM. D ONOT
LIFTTHEOVENWITHTHESIDETRIM.
Sidetrim will notsupport the weightofthe oven,
• Reinove tile two side triin screws and install
the opposite side triIn piece.
• Careflilly, lift tile oven bv tile bottoIn and
slide straight back into tile opening. Check
to be sure power cord is not trapped beneath
tile ()veil.
St
Drive
Installation
S€iye_/)s
• Using tile installation holes as a guide, drill
two (2) pilot holes (1/8" diameter) into tile
cabinet.
• Install tile two (2) installation screws.
CAUTION: Placetape or
cardboard overtrim edges to
prevent damage while drilling
pilot holes.
t ..............