Table of Contents
Advertisement
8
Installation
1.Verify compatibility, certain radios require
antenna adapter(s), not included in the kit.
2. Disconnect battery
3. Remove radio from car
4. Set the DIP switches for the frequency
selector switch to the desired setting.
OFF
ON
5. Install Universal RDS cable. Plug the fac-
tory radio antenna to the receptacle on the
module.
UNIVERSAL RDS
6. Test for 12V constant, 12V switched, and ground sources.
Splice into with leads from power cable.
7. Route kit to glovebox or other accessible location.
8. Connect battery & test*
9. Complete install by re-installing radio
10. Save frequency to a preferred preset on the radio if
desired.
Advertisement
Table of Contents
