Table of Contents
Advertisement
Check the monitor settings —
See the monitor documentation for instructions on adjusting the contrast and brightness, demagnetizing (degaussing) the
monitor, and running the monitor self-test.
Power Lights
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
The power button light located on the front of the computer illuminates and blinks or remains solid to indicate different states:
If the power light is green and the computer is not responding, see
l
If the power light is blinking green, the computer is in standby mode. Press a key on the keyboard, move the mouse, or press the power button to
l
resume normal operation.
If the power light is off, the computer is either turned off or is not receiving power.
l
Reseat the power cable into both the power connector on the back of the computer and the electrical outlet.
¡
If the computer is plugged into a power strip, ensure that the power strip is plugged into an electrical outlet and that the power strip is turned
¡
on.
Bypass power protection devices, power strips, and power extension cables to verify that the computer turns on properly.
¡
Ensure that the electrical outlet is working by testing it with another device, such as a lamp.
¡
Ensure that the main power cable and front panel cable are securely connected to the system board (see
¡
If the power light is blinking amber, the computer is receiving electrical power, but an internal power problem might exist.
l
Ensure that the voltage selection switch is set to match the AC power at your location, if applicable.
¡
Ensure that the processor power cable is securely connected to the system board (see
¡
If the power light is steady amber, a device may be malfunctioning or incorrectly installed.
l
Remove and then reinstall the memory modules (see Memory).
¡
Remove and then reinstall any cards (see Cards).
¡
Eliminate interference. Some possible causes of interference are:
l
Power, keyboard, and mouse extension cables
¡
Too many devices on a power strip
¡
Multiple power strips connected to the same electrical outlet
¡
Diagnostic Lights
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
To help troubleshoot a problem, your computer has four lights labeled 1, 2, 3, and 4 on the front panel (see
the lights flash before turning off. If the computer malfunctions, the sequence of the lights help to identify the problem.
NOTE:
After the computer completes POST, all four lights turn off before booting to the operating system.
Light Pattern
Problem Description
The computer is in a normal off
condition or a possible pre-BIOS
failure has occurred.
The diagnostic lights are not lit
after the system successfully
boots to the operating system.
A possible processor failure has
occurred.
Memory modules are detected,
but a memory failure has
occurred.
Diagnostic
Lights.
Suggested Resolution
Plug the computer into a working electrical outlet (see
l
If the problem persists, contact Dell (see
l
Reseat the processor (see Processor).
l
If the problem persists, contact Dell (see
l
If two or more memory modules are installed, remove the modules (see
l
reinstall one module (see
Installing
normally, continue to install additional memory modules (one at a time) until you have identified a
faulty module or reinstalled all modules without error.
If available, install working memory of the same type into your computer (see
l
If the problem persists, contact Dell (see
l
System Board
System Board
Components).
Front
View). When the computer starts normally,
Power
Problems).
Contacting
Dell).
Contacting
Dell).
Memory) and restart the computer. If the computer starts
Contacting
Dell).
Components).
Removing
Memory), then
Installing
Memory).
Advertisement
Table of Contents
