Charging Battery; Installing Memory Card; Transferring Files - Denver TAC-7018 User Manual

f. Micro USB Port –Connects to PC via USB cable.
g. Power – Press and hold to turn on or off the unit; briefly press to lock or
unlock the screen.
h. VOL+/- –Increase/ decrease the volume.
i. Earphone socket –connects to stereo earphones.
j. Built-in Speakers
k. MicroSD card Slot
l. Microphone /Reset pin hole –Audio input; reset your device if the device
freezes.
Note: DO NOT insert or remove the memory card when the device is working with it. That
may cause errors or other failures.
The device has a built-in rechargeable battery. No extra battery installation is required.
Just charge the device when it indicates low battery.
To charge the battery, connect the device to any standard wall outlet via the DC-IN
port using the power adaptor. It takes about 5 hours to fully charge the battery. When
the battery is fully charged, the charge indicator should light up in orange. During
charging, the indicator lights up in red.
Note:
a. You are strongly recommended to charge the battery immediately when the device indicates the
battery is lower than 15%!
b. You can operate the device even when it is being charged. But for extended battery life, it is suggested
NOT to use the device when it is charging.
c. It is recommended to charge the battery before you use the device for the first time.
d. For maximum performance, lithium-ion batteries need to be used often. If you don' t use the device
often, be sure to recharge the battery at least once per month.
e. Be sure to use only the dedicated power adaptor provided with the unit for charging.
This device can read files directly from memory card.
To use a memory card, find the card slot on the device and then insert the memory
card into the slot in the correct orientation. To access the files stored in the memory
card, enter the Explorer mode by tapping the Explorer icon and select the " SD Card"
directory.
Before reading or playing files, you need to transfer media files from a computer to the
device.
(1) Connect the device to a computer with the supplied USB cable.
(2) Oncetheconnectionis done, thedevice willnotifyyouthattheUSBdeviceisconnected
as media device.
(3) Instantly, two removable disk drives will show on your computer, one standing for the
internal memory of the device, and the other standing for the memory card inside it.

Charging Battery

Installing Memory Card

Transferring Files

6