Table of Contents
Advertisement
EMI Shield, Video Board, and Palm Rest: Dell Latitude V710/V740 Service Manual
Back to Contents Page
EMI Shield, Video Board, and Palm Rest
Dell™ Latitude™ V710/V740 Service Manual
EMI Shield
Video Board
Palm Rest
EMI Shield
NOTICE:
Disconnect the computer and any attached devices from electrical outlets, and remove any
installed batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted
metal surface on the computer.
NOTICE:
Read
"Preparing to Work Inside the
procedure.
1. Remove the keyboard.
2. Remove the two M2.5 x 5-mm screws that secure the display-feed flex cable to the system board.
NOTICE:
When reconnecting the display-feed flex cable connector to the system board, push down on the
top left and right ends of the connector. Pressing on the center of the connector may damage resistors and
compromise EMI protection in the computer.
3. Pull up on the pull tab that is attached to the display-feed flex cable connector to remove the connector
from the system board.
4. Remove the three M2.5 x 12-mm screws that secure the EMI shield to the bottom case, and pull the EMI
shield out of the bottom case.
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/...40/v710%20v740%20SERVICE_MANUAL/palmrest.htm (1 of 11)6/21/2004 2:57:05 AM
Computer" before performing the following
Advertisement
Table of Contents
