Table of Contents
Advertisement
Display Assembly and Display Latch: Dell Latitude V710/V740 Service Manual
NOTICE:
Disconnect the computer and any attached devices from electrical outlets, and remove any
installed batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted
metal surface on the computer.
NOTICE:
Read
"Preparing to Work Inside the
procedure.
1. Remove the keyboard.
2. Remove the
display
3. Remove the
display
4. Remove the two M2 x 3-mm screws on the left side of the display panel.
5. Remove the two M2 x 3-mm screws on the right side of the display panel.
6. Remove the M2.5 x 5-mm screw that secures the display-feed flex cable to the display assembly.
7. Unsnap the flex-cable retention bracket from the top cover, and lift the bracket out of the display assembly.
1 flex-cable retention bracket
8. Lift the display panel from the top, and rotate the display panel out of the top cover.
9. Disconnect the bottom flex cable connector from the inverter connector on the system board by pulling on
the attached pull tab away from the inverter connector.
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/L...V740/v710%20v740%20SERVICE_MANUAL/display.htm (5 of 8)6/21/2004 2:57:02 AM
assembly.
bezel.
Computer" before performing the following
Advertisement
Table of Contents
