Taillamps - GMC 2013 Savana Owner's Manual

1. Use a small tool to unlatch the
outboard clip on the lamp by
pushing inboard and prying the
lamp assembly forward.
2. Remove the lamp from the grille.
3. Turn the bulb socket
counterclockwise one-quarter
turn and remove it from the lamp
assembly.
4. Remove the bulb from the
socket by pulling it straight out.
5. Replace the bulb.
6. Turn the bulb socket clockwise
to reinstall it in the lamp
assembly.
7. Reinstall the lamp assembly into
the grille until the outboard clip
snaps into place.
To replace a taillamp/turn signal
lamp or back-up lamp bulb:
1. Remove the two inboard nuts
from the inside of the taillamp
assembly.
2. The third nut (3) is under the
applique piece (2) above the
lamp. Remove the two inboard
applique nuts. Pull the
applique (2) straight rearward
slightly to clear the studs. Then
rotate the applique (2) just far
enough to gain access to the
outer push pins (1).
3. Carefully disconnect the push
pins (1) from the applique
bracket.
4. Remove the third nut (3) from
the upper outboard side of
the lamp.