Vehicle Messages; Engine Hours; Relearn Tire Positions; Calibrate Compass - GMC 2013 Savana Owner's Manual

If a low tire pressure condition is
detected by the system while
driving, a message advising you to
check the pressure in a specific tire
will appear in the display. See
information.
If the tire pressure display shows
dashes instead of a value, there
may be a problem with the vehicle.
If this consistently occurs, see your
dealer for service.

Engine Hours

Press until ENGINE HOURS
displays. This display shows the
total number of hours the engine
has run.

Relearn Tire Positions

The vehicle may have this display.
To access this display, the vehicle
must be in P (Park). If the vehicle
has the Tire Pressure Monitor
System (TPMS), after rotating the
tires or after replacing a tire or
sensor, the system must re-learn the
tire positions. To re-learn the tire
positions, see
and
for more information.
Change Compass Zone
The vehicle may have this feature.
To change the compass zone
through the DIC, see

Calibrate Compass

The vehicle may have this feature.
The compass can be manually
calibrated. To calibrate the compass
through the DIC, see
Blank Display
This display shows no information.
Instruments and Controls
. See
,
and
for more
.
.

Vehicle Messages

Messages displayed on the DIC
indicate the status of the vehicle or
some action may be needed to
correct a condition. Multiple
messages may appear one after
another.
The messages that do not require
immediate action can be
acknowledged and cleared by
pressing (Set/Reset).
The messages that require
immediate action cannot be cleared
until that action is performed.
All messages should be taken
seriously and clearing the message
does not correct the problem.
The following are the possible
messages and some information
about them.
If the vehicle has a diesel engine,
see the Duramax diesel
supplement.
5-29