Ignition Positions - Buick 2013 LaCrosse Owner's Manual

Hide thumbs Also See for 2013 Buick LaCrosse:
Table of Contents

Advertisement

above 110 km/h (68 mph)
should be limited to
five minutes per use.
Avoid making hard stops for
the first 322 km (200 mi) or
so. During this time the new
brake linings are not yet
broken in. Hard stops with
new linings can mean
premature wear and earlier
replacement. Follow this
breaking-in guideline every
time you get new brake
linings.
Do not tow a trailer during
break-in. See
for the
trailer towing capabilities of
your vehicle and more
information.
Following break in, engine speed
and load can be gradually
increased.

Ignition Positions

(Keyless Access)
The vehicle has an electronic
keyless ignition with pushbutton
start.
Pressing the button cycles it through
three modes, ACC/ACCESSORY,
ON/RUN/START, and Stopping the
Engine/OFF.
The transmitter must be in the
vehicle for the system to operate.
If the pushbutton start is not
working, the vehicle may be near a
Driving and Operating
strong radio antenna signal causing
interference to the keyless access
system. See
for more information.
To shift out of P (Park), the vehicle
must be in ACC/ACCESSORY or
ON/RUN and the brake pedal must
be applied.
Stopping the Engine/OFF (No
Indicator Lights): When the
vehicle is stopped, press the engine
START/STOP button once to turn
the engine off.
If the vehicle is in P (Park), the
ignition will turn off, and Retained
Accessory Power (RAP) will remain
active. See
information.
If the vehicle is not in P (Park), the
ignition will return to ACC/
ACCESSORY and display the
message SHIFT TO PARK in the
Driver Information Center (DIC).
See
for more information.
9-15
for more

Advertisement

Table of Contents
loading

Table of Contents