Cable Management Arm - Dell PowerEdge T320 Technical Manual

Table 19 lists the supported rack types for the T320.
Rail
Product
Identifier
T320 C2
Screws are not included in the kit due to the fact that threaded racks are offered with a variety of
thread designations. Other factors to consider when deploying the T320 include the spacing
between the front and rear mounting flanges of the rack, the type and location of any equipment
mounted in the back of the rack such as power distribution units (PDUs), and the overall depth of
the rack.
For detailed information about sliding rails, see the Rack rail specifications in Appendix A. For more
information on installing the T320 in a rack, see the
Support.Dell.com/Manuals.
The optional CMA organizes and secures the cords and cables exiting the back of the server and
unfolds to allow the server to extend out of the rack without having to detach the cables. Some key
features of the T320 CMA include:
 Large U-shaped baskets to support dense cable loads
Open vent pattern for optimal airflow

Ability to be mounted on either side

 Use of hook-and-loop straps rather than plastic tie wraps to eliminate the risk of cable damage
during cycling
Low-profile fixed tray to both support and retain the CMA in its fully closed position

Ability to mount the CMA and tray without the use of tools, due to snap-in designs

Mounting Interface
ReadyRails II
Rack Types Supported
Rail Type
4-Post
Square Round
 
Sliding
Rack Installation Instructions
2-Post
Thread Flush Center
 X X
on