Checking Total Memory - Toshiba Satellite P40 User Manual

6 Turn the computer right side up. Make sure to remove
the soft cloth from the work surface before restarting the
computer.
7 Reconnect the cables.
8 Restart the computer.

Checking total memory

When you add or remove a memory module, you can check
that the computer has recognized the change. To do this:
Press the (
The
(RAM)
If the computer does not recognize the memory
configuration, turn off the computer and remove the memory
module slot cover (complete steps
memory module" on page
module is inserted completely into the socket and lined up
squarely with the socket latches.
Always make sure your computer and AC adaptor have
adequate ventilation and are protected from overheating
when the power is turned on or when an AC adaptor is
connected to a power outlet (even if your computer is in
Sleep mode). In this condition, observe the following:
Never cover your computer or AC adaptor with any object.
Never place your computer or AC adaptor near a heat
source, such as an electric blanket or heater.
Never cover or block the air vents including those located
at the underside of the computer.
Always operate your computer on a hard flat surface.
Using your computer on a carpet or other soft material
can block the vents located at the underside of the
computer.
Overheating your computer or AC adaptor could cause
system failure, computer or AC adaptor damage or a fire,
possibly resulting in serious injury.
TECHNICAL NOTE: You must have at least one memory
module installed for the computer to work.
) +
X
window appears.
System
is displayed below the System heading.
Getting Started
Removing a memory module
keys, and then click
Installed memory
1-10
48), and then check that the
.
System
in "Installing a
55