Tray Removal For Sensors, Belts, & Diagnostic Access - Panasonic SAHT730 - DVD THEATER RECEIVER Technical Manual

4. Tray Removal for Sensors, Belts, & Diagnostic Access
Removing the tray to access the sensors and motor first requires removing the tray
trim, and then the front panel (not shown) before the tray assembly will come out.
Follow figure 2 for easy tray removal. CAUTION – metal chassis edges are sharp.
Quick Procedure:
1. Rotate the white Close Lock Gear / lever CW (clockwise) within the turntable
platter to unlock the tray. Pull the tray forward (towards yourself) until it stops.
2. From the bottom of the black tray, remove the front silver trim piece (not
shown).
3. Unplug the two front panel cables (CN2008 & CN2009) and remove the front
panel (not shown).
4. On the main board, remove the cable (CN2010) attached to the tray.
5. Move the rear white lever counter-clockwise (CCW) as shown in figure 2 and
at the same time
6. Release the two parallel tray stops (a and b) by pressing the larger tab
(closest to you) inward toward the center of the tray (figure 2).
7. Slide the tray out towards yourself to expose the sensors, motors, and belt.
6a
1.
2. Remove
trim from
the bottom.
SA-HT730 / SAHT930
5.
Figure 2 – Tray removal revealed
8
6b
CN2010
Contacts = rear
CN2008
Contacts = left
CN2009
Contacts = rear