Table of Contents
Advertisement
Symptom
Shutdown and Startup Problems
The Suspend/Resume button does not work.
The system powers up, and displays the
power on information, but fails to load the
operating system.
T r o u b l e s h o o t i n g
Possible Cause
6. The batteries are too hot or too cold.
(See Batteries on page 26.)
1. The Suspend/Resume button is disabled from
the Advanced submenu of the Power Savings
menu of the setup utility.
2. You did not hold the button in long enough.
3. There may be a conflict with the
application software.
1. The boot sequence settings of the setup utility
are not compatible with your configuration.
L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u
Possible Solution
6. Restore the notebook to normal operating
temperature. (The Charging indicator on
the Status Indicator panel will flash when
the battery is outside its operating range.)
1. Enable the button from the setup utility.
(See page 102.)
2. Hold the button longer. This may need to
be a very long time if your application is
preventing the CPU from checking for
button pushes.
3. Close all applications,and try the
button again.
1. Set the operating source by pressing the Esc
key while the Fujitsu logo is on screen or use
the F2 key and enter the setup utility and
adjust the source settings from the Boot
menu on pages 106–107.
161
Advertisement
Table of Contents
