Xircom OP-720-69001 - RealPort CardBus Ethernet 10/100 User Manual page 10

2-2
RealPort Ethernet 10/100Modem 56 User's Guide
Xircom Utilities
8 Use Start/Run to execute A:\SETUP.EXE from the Xircom
diskette. Xircom utilities and online documentation will be
installed in a program group on your hard disk.
9 Remove the Xircom diskette and reboot the system.
Power-Saving Modes
The Xircom RealPort Ethernet 10/100+Modem 56 adapter has
three modes that can be used to reduce power consumption by
disabling a function that is not being used: Network-only, Modem-
only, and Network & Modem (default).
To specify a power-saving mode, select Network from Control
Panel, select the Configuration tab, select Network of Xircom
Ethernet 10/100 + Modem 56 and click Properties, select the
Advanced tab, and select a mode in the Function(s) property that
matches your requirements.
Troubleshooting Guidelines
Additional information on Windows 95 and 98 can be found, after
running the Xircom program SETUP.EXE, in the Xircom program
group.
Troubleshooting Network Installation
Review this section if any of the following problems occur:
• The Xircom RealPort Ethernet 10/100+Modem 56 is not
detected during installation.
• After installation there is an exclamation point (!) on the
Network of Xircom Ehternet 10/100 + Modem 56 entry listed
under Network Adapters in Device Manager.
• The RealPort Ethernet 10/100+Modem 56 appears to have
installed correctly but you cannot access network resources.
Use the following steps to verify that the PCMCIA Card Socket
controllers are enabled.
1 In the Control Panel, double-click the System icon.
2 Click the Device Manager tab.