Dell PowerConnect W-AP134 Installation Manual page 3

Figure 2
W-AP130 Series Rear
Reset Button
DC Power Socket
ENET 1
CONSOLE ENET 0 Kensington Security Slot
Console Port
Use the console port to connect to a terminal for direct local management.
Ethernet Ports
W-AP130 Series is equipped with two10/100/1000Base-T (RJ-45) auto-sensing, MDI/MDX wired-network
connectivity port. These ports support IEEE 802.3at Power over Ethernet (PoE) compliance, accepting 56VDC as
a standard defined Powered Device (PD) from a Power Sourcing Equipment (PSE) such as a PoE midspan
injector, or network infrastructure that supports PoE.
DC Power Socket
If PoE is not available, an optional Dell AP AC-DC adapter kit (sold separately) can be used to power the
W-AP130 Series.
Reset Button
The reset button can be used to return the AP to factory default settings. To reset the AP:
1. Power off the AP.
2. Press and hold the reset button using a small, narrow object, such as a paperclip.
3. Power-on the AP without releasing the reset button. The power LED will flash within 5 seconds.
4. Release the reset button.
The power LED will flash again within 15 seconds indicating that the reset is completed. The AP will now
continue to boot with the factory default settings.
Kensington Lock Slot
The W-AP130 Series is equipped with a Kensington security slot for additional security.
Dell PowerConnect W-AP130 Series Access Point | Installation Guide 3