Advertisement
Installation
1. Before securing your mount to a double-gang box or directly to the wall, route the ethernet cable
through the openings show in
Figure 3 Cable Routing
2. Install your mounting bracket.
For the Wall Mount Bracket
a. Before installing your Wall Mount Bracket, install the appropriate wall anchors. Screws and wall
anchors are not included.
b. Align the screw holes in the mount with the holes or anchors on the wall.
c. Insert the screws and tighten them to secure your Wall Mount Bracket.
Figure 4 Wall Mount Bracket Installation
For the Box Mount Bracket:
If you plan to permanently connect a serial console cable to the AP installed over a gang-box, you must use the
Wall Mount Bracket instead of the Box Mount Bracket. This provides the necessary space behind the AP to run
both cables.
N O T E
a. Align the screw holes in the mount with the those in the gang box, as shown in
b. Insert the screws and tighten them to secure your Box Mount Bracket.
2
Figure
3.
Cable from
Gang Box
Box Mount Bracket
(Figure
4):
Wall Mount Bracket
Cable Route
to ENET Port
Figure
AP-105 Mounting Kit
5.
| Installation Guide
Advertisement
