AP-105 Mounting Kit Installation Guide Introduction The AP-105 Wall Mounting kit provides two options, with built-in security features, for mounting your AP-105 to a wall. Use the Box Mount Bracket to install the AP over wall box and use the Wall Mount Bracket to install the AP directly on a wall.
Installation 1. Before securing your mount to a double-gang box or directly to the wall, route the ethernet cable through the openings show in Figure Figure 3 Cable Routing Wall Mount Bracket Cable from Gang Box Cable Route Box Mount Bracket to ENET Port 2.
Page 3
The box mount bracket can also be installed over a double-gang wall box. Use the same steps as above to install it over a double-gang wall box, however the installation requires a third screw. For more details, see Figure Figure 5 Box Mount Bracket Installation (Single-gang Box) Figure 6 Box Mount Bracket Installation (Double-gang Box) AP-105 Mounting Kit | Installation Guide...
Page 4
3. Connect the ethernet cable to the ethernet port (ENET) on the back of the AP. 4. Secure the AP to the mounting bracket by aligning the mounting holes on the back the AP with the mounting post on the bracket. 5.
Page 5
6. To remove the AP from the mounting bracket, begin by inserting an M5 or 3/16" hex key into the hole shown in Figure 7. Use the hex key to depress the tab on the AP and push the AP up, releasing the AP from the mounting post on the bracket.