Camera Module; Removing The Camera Module - Dell Inspiron 1428 Service Manual

Camera Module

WARNING:
Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell™ is not covered
by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery
(see "Removing the Battery" on page 13) before working inside the computer.

Removing the Camera Module

1 Follow the procedures in "Before You Begin" on page 9.
2 Remove the battery (see "Removing the Battery" on page 13).
3 Remove the hinge cover (see "Removing the Hinge Cover" on page 15).
4 Remove the keyboard (see "Removing the Keyboard" on page 17).
5 Remove the display assembly (see "Removing the Display Assembly" on
page 47).
6 Remove the display bezel (see "Removing the Display Bezel" on page 51).
7 Remove the inverter board (see "Removing the Inverter Board" on
page 59).
8 Remove the display panel (see "Removing the Display Panel" on page 53).
9 Remove the two screws that secure the camera module to the display
cover.
10 Slide the camera module towards the right to release it from the display
cover.
15
Camera Module
63