Fujitsu Lifebook E-6624 Bios Manual page 6

L i f e B o o k E S e r i e s B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA devices are installed.
Main
Primary Master [HITACHI_DK23CA-30-(PM)]
Type:
Cylinders:
Heads:
Sectors:
Maximum Capacity:
Multi-Sector Transfers:
LBA Mode Control:
PIO Transfer Mode:
DMA Transfer Mode:
F1 Help
ESC Exit
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field Options
Type: Auto
None
CD-ROM
SuperDisk
Hard Disk
Cylinders: A number between
0 and 65,535
Heads: A number between
1 and 16
Sectors: A number between
0 and 63
Maximum Display only
Capacity:
6
PhoenixBIOS Setup Utility
[Hard Disk]to]
[16383]
[16]
[63]
8455MB
[16 Sectors]
[Enabled]
[Fast PIO 4]
[Ultra DMA 5]
Select Item -/Space
Select Menu Enter
Figure 2. Primary Master Submenu
Default
[Auto]
–—
–—
–—
–—
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Change Values F9
Select Sub-Menu F10
Description
Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the BIOS at POST. If None is selected, all
of the following Set-up items do not appear. Select CD-ROM if a
CD-ROM drive is installed at this connection. If Hard Disk is
selected, you must specify the number of Cylinders, Heads, and Sec-
tors for the drive.
This item is active only when Hard Disk is selected as the type. This
field is changed by incrementing (pressing the [Spacebar]) or by typ-
ing in the number.
This item is active only when Hard Disk is selected as type. You can
change the value by incrementing (pressing the [Spacebar]) or by
typing in the number.
This item is active only when Hard Disk is selected as type. You can
change the value by incrementing (pressing the [Spacebar]) or by
typing in the number.
Displays the maximum capacity of the drive calculated from the
parameters of the hard disk when Auto is selected and the type
is identified as hard disk.
Setup Defaults
Save and Exit