Installing The Device; Desktop Installation; Rack Mount Installation - Dell PowerConnect B-FCXs Getting Started Manual

Installing the device

You can install Dell devices on a desktop or in an equipment rack.
CAUTION
Make sure the rack or cabinet housing the device is adequately secured to prevent it from
becoming unstable or falling over.

Desktop installation

FIGURE 3
Attaching the adhesive feet
1. Attach the four adhesive feet to the bottom of the first switch.
2. Set the device on a flat desktop, table, or shelf near an AC power source. Make sure that adequate ventilation is
provided for the system. A 7.62 cm (3 in.) clearance is recommended on each side.
3. If installing a single switch only, refer to
4. If installing multiple switches, attach the adhesive feet to each one. Place each device squarely on top of the
one below, in any order.

Rack mount installation

NOTE
You need a #2 Phillips screwdriver for installation.
Before mounting the switch in a rack, pay particular attention to the following factors:
•
Temperature: Since the temperature within a rack assembly may be higher than the ambient room temperature,
check that the rack-environment temperature is within the specified operating temperature range. (Refer to
Table 3 and Table 4 following.
PowerConnect B-Series FCX/FCXS Getting Started Guide
53-1002049-01
"Powering on the system" on page 16.
11