Table of Contents
Advertisement
3
Enter the password with the keypad
and press the Enter button.
Reenter the password and press the
Enter button.
You can use up to 7 alphanumeric
characters for a password but you
cannot use special characters.
The ← key on the keypad performs
the role of Delete and the ◄ button
performs the role of the Cancel (Esc)
function.
To enter a number, press Num
Lock and then enter the number.
If you do not press Num Lock, the
characters of the corresponding
keys are entered instead of digits.
4
When a message confirming the
password configuration appears in
the [Setup Notice] window, press
<Enter>.
The supervisor password has been
set. The supervisor password is
required to turn the computer on or to
enter System Setup.
Setting a User Password
Users can start the system with a user
password, but cannot enter the System
Setup. By doing this, you can prevent
other users from entering Setup.
Before configuring a user password, a
supervisor password must have been
configured. Deactivating the supervisor
password also deactivates the user
password.
In the Set User Password item, press
<Enter> and complete the procedures of
Step 3 of Setting a Supervisor Password.
Activating the Booting Password
Before activating the booting password,
a supervisor password must have been
configured.
Set the Password on boot option to
Enabled. From now on, system booting
will not proceed without the password.
154
Advertisement
Table of Contents
